DigiMask™ Standard Paper
DigiMask® is an ultra-low tack, standard weight paper masking designed for the surface protection of digital prints. Following graphics application, RTape's DigiMask surface protection products can be easily removed from the graphics. This easy-removal characteristic reduces the risk of pulling overlaminates away from prints or pulling the installed graphic from the application substrate, even when installing large format graphics with low initial tack or repositionable adhesives.
Tech Data Sheet
|Caliper facestock||89 - 102 microns (3.5 - 4.0 mils)|
|Caliper facestock + adhesive||112.5 - 125 microns(4.5- 5.0 mils)|
|Adhesion to Steel*||1.1-3.2 N/100mm (1 - 3oz.)|
|Tensile||297 N/100mm (17lb./in)|
|Elongation||3 - 4%|
|Tear Resistance||50 grams|
|Light Transmission [3mm thick]|
|Gloss (60 degree angle)|
|Shelf Life**||1 year|
|Gloss (75 degree angle)|
|Temperature Limit (F)|
|Temperature Limit (C)|
|Chemical Resistance (Water)|
|Chemical Resistance (10% Nacl)|
|Chemical Resistance (38% H2S04)|
|Chemical Resistance (Ethanol)|
|Chemical Resistance (Aceton)|
Printer profiles are available on rtape.com.
Tapes are only warranted to be free of defect in workmanship or materials at time of shipment. Manufacturer will replace or credit any material manufacturer deems defective. No acceptance or responsibility for loss, damage, or expense, implies or otherwise, shall be assumed by seller or manufacturer. User assumes all risk and liability herewith.