Removing Rock Hard Tape Adhesive

Every so often, we get a service call involving a sign maker or painter, who cannot remove the adhesive of our application tape from a substrate. We just received one yesterday from a woman in Southern California, who left masked painted panels in the sun. The panels became so hot that she could not handle the substrate without wearing gloves. The scorching summer heat had baked on the masking.

Many of our customers use our paper application tapes as a protective masking for substrates or for painting. Masking on products stored indoors and not exposed to high heat should remove without problems. When paper application tape is exposed to high heat and prolonged sunlight, however, you can encounter big trouble that may be irreparable.

In another case, an automotive painter used our application tape to mask the chrome bumper of a classic car, while he was spraying paint. This is a great application for the product. The problem occurred when he failed to remove the tape after painting. After he finished the job, the car was left outside for weeks. In that time the adhesive hardened. He tried everything to remove the masking, including water, mineral spirits, turpentine, lacquer thinner and naphtha. While the paper eventually came off, the adhesive still remained. No amount of solvent could dissolve the adhesive.

Here's what we think is happening. With exposure to heat and UV light, the co-adhesive strength of the rubber adhesive increases until it crystallizes and hardens. As the adhesive hardens, it becomes less and less soluble. At some point in time, the adhesive becomes so hard that it loses any solubility at all. Once the adhesive becomes hard as a rock, there is nothing you can do, unfortunately. At RTape we tested a wide range of solvents, hoping to find that one chemical that will remove hardened adhesive. Neither we nor any other of the manufacturers have discovered that magic potion. The good news is that if you have masked glass and the adhesive hardens, you can at least scrape the residue off the a razor scraper.

We can give you two pieces of advice:

  • Do not store masked materials outdoors or anywhere exposed to high heat.
  • If you are using application paper as a masking for painting, remove the masking when you are finished painting.

 



Blog Categories


Recent Posts

Whether you are installing trailer graphics or doing a full wrap of a car or van, surface preparation involves a three-step process of detergent washing, solvent cleaning and a final wipe down with IPA. Read more


Whether you are screen printing or painting, the coating must bond to the substrate for the service life of the product. Depending on the physical properties of the coating that you have selected for a project and the substrate to which the coating will be applied, the paint or ink adheres in a few different manners. Read more


Adhesion failures of pressure sensitive materials, such as labels, decorative films, foam tapes and graphic panels, to powder coated substrates are quite common. Just as there are several reasons for these failures, there are several steps that the fabricator can take to avoid these problems. Read more


View All