An Alternative to Spray Adhesive for Textile Printers

Many years ago, I had one of those bright ideas that backfired on me. Instead of extruding lines of adhesive across the web of a production line laminating one sheet of paper to another, I replaced the extrusion heads with six spray values.

I learned an important lesson. Anytime you atomize something, it gets into the air. You may not see the miniscule particles of adhesive. Nevertheless, a mist of glue gets over everything. In no time the equipment was covered with adhesive.

Printers, who spray aerosol adhesives in a garment print shop, experience the same problem but to a much lesser extent. I recently discovered an alternative for spray products. It’s a non-aerosol adhesive that you spread onto a pallet with a squeegee. Not only is it a cleaner application, it’s also a little more environmentally friendly.

The new adhesive is Tekmar TB-HV. Because it is water-based, it is non-flammable, unlike some spray adhesives. Using this product is also healthier. It has none of those nasty VOCs that pollute the air. And if you follow the product instructions, it is also non-hazardous.

One printer, who was using RTape Protek™ pallet protection tape, asked if you could apply the new adhesive to the paper tape. His concern was that the water-based adhesive would penetrate the paper resulting in the tape delaminating from the pallet. Not a problem!

If you use the adhesive sparingly, this should not occur. In the photo below I have applied the Protek™ tape to the pallet. Then I spread a very thin bead of adhesive at the top of the pallet.

Using a squeegee, quickly spread the adhesive over the entire surface of the pallet, as show below. If you need more adhesive, just apply a dab more and spread that out too. The key is to use the least amount of adhesive to accomplish the task.

When you are done, clean up is a piece of cake. Because the adhesive is water-based, you can easily wash off your squeegee with warm water. If the adhesive on the tape gets dirty, just replace the old pallet protection tape with a new piece and reapply the adhesive. When you are working with this adhesive, I recommend wearing latex gloves to prevent skin contact and the potential for any allergic reaction.



Blog Categories


Recent Posts

With the right film, the right application tools and the right techniques, vinyl graphics can be applied to textured wall surfaces such brick and concrete block. Many of old time decal applicators would heat a cast vinyl with an industrial heat gun, and burnish the hot, pliable film into the textured surface using a rivet brush for this job. Read more


The plethora of terms used for the application tapes sold in the sign and screen print markets could confuse anyone. In the sign market, many people just use the terms “application tape” or “application paper”. Frequently this tape is also incorrectly referred to as “transfer tape”.
If you are a purist and want to pick a few nits, the terms application tape and transfer tape refer to completely different products. Transfer tape refers to a transfer adhesive, which is an adhesive coated onto a release liner.

Read more


Many shops, which have printed wall murals in which the ink bleeds to the edge of the panel, have experienced edge curl issues with a variety of vinyl films. For permanent wall graphics applications, I would consider using Arlon’s DPF 8000 film. DPF 8000 is a 3.5 mil (90 micron) satin white calendered vinyl, designed for long term indoor and outdoor applications. It features an aggressive, permanent pressure-sensitive adhesive that sticks to those “hard-to-stick-to” surfaces.
Read more


View All